💡 Top tip: The Acteon UScan was previously known as Villa Scanograph - configure it via the Owandy/Villa module, as it uses the same driver as the Villa scanner. The site will need to be on V8 for this to work.
How do I set up Acteon UScan to work with EXAMINE Pro?
Firstly enable the X-Ray Owandy Module.
Within the Owandy module, go to the 'Sensors' tab and select the 'IngxCli (USB/WiFi)' tab, then tick the enabled box. Ensure 'Ask for sensor files' near the bottom of the screen is unticked.
Ensure the X-Ray Owandy/Villa module is selected with X-ray Acquisition.
Make sure the Villa standalone program is running before you enter the EXAMINE Pro acquisition screen. This can be started via a shortcut on the desktop or automatically when Windows starts (right-click on the red or green sensor icon in the system tray).
The option 'Start when Windows starts' should be checked.
Within the acquisition screen you should see the scanner interface. When it is green it means it is connected and ready to scan - it will go yellow when busy scanning.
EXAMINE Pro will also report on the status of the scanner at the bottom of the screen.
After a scan is taken there is also a dose indicator.
If the below screen appears, this is because they aren’t scanning the plates in the correct way.
